If the symbol “water tap” appears on the display of your dishwasher please follow these 3 steps to resolve the problem.

1. Check that there are no kinks in the cold water fill hose and the waste water hose by pulling the appliance out slightly and untwisting any visable kinks or bends in these hoses. Pull the appliance out slightly and untwist any visible kinks.

2. Check the water pressure directly from the tap using a bucket. Approximately 10 litres of water per minute should flow out of the tap when fully open. If the water pressure is too low, you may need to contact

Step-by-step guide: How to check the water pressure

Check the water pressure of the tap.

Close the water tap and remove the hose.

Put a bucket below the tap and turn off the water tap.

Approximately 10 liters of water per minute should come out.

If the water pressure is too low, you may need to contact your plumber to check the water installation.

3. Check if your filter is blocked. If the filters in the water connection of the supply or AquaStop hose are blocked, make sure to clean the filter in the inlet hose.

If issue persist, we advise against attempting repairs yourself. Instead, book a repair with one of our highly trained and qualified Bosch engineers.