• Bosch corporate

Built-in Ovens

> Home
Preparing the unit for installation
  • Cabinet units and adjacent cabinets of the appliance should be heat-resistant for up to 90° and 70° respectively
  • Electrical installation should always be performed by qualified technicians.
  • For ergonomic comfort, install the appliance up to a height which allows you to safely take trays and hot food easily in and out of the oven.
  • For ventilation purpose, allow cool air to enter from the bottom of the cabinet through an opening and remove the back panel of the cabinet.
  • Cable Length: 1.2m (direct wiring is recommended for models with electrical power that is more than 3000watt).
Preparing the unit for Ventilation
  • Ensure there is no backing panel behind the oven and minimum 20mm gap must be provided.
  • Recommended 100cm gap below the cabinet. Width of opening minimum 460mm.
min. 20mmmin. 100mm²
Power point for Ventilation
Ideal to have powerpoint in the cabinet next to oven niche, however, if it is not possible, have it directly behind the oven.
  • In case of the need to have backing as a support frame work, here must have at least a 200mm x 400mm opening here for air ventilation.
  • To install wire netting to prevent foreign matters dropping into cabinet.
  • Height depends on the appliance model
  • Maintain a minimum 5mm gap between the oven/steam oven fascia panel and the cabinet
  • If the appliance is installed under a hob, maintain a ventilation gap specified by the installation manual or at least 30mm between the table top and top of the oven.
  • The power socket for the appliance must either be located in the hatched area A or away from the installation space.
  • For corner installation, check minimum clearances. Ensure that there is sufficient clearance A for the front panel and its handles. Check that the appliance door can be opened properly.
  • A gap of 45mm should be maintained between the appliance and wall. There should not be a back panel behind the appliance.
  • Intermediate flooring is required when one appliance is on top of another. Only exception is when the appliance is installed above a warming drawer.
  • Recommended ventilation area of 100cm² at the base of the cabinet.
These are the clearances to take note of. Refer to build under requirements for installation and ventilation measurements.
  • A gap of 35mm (except for model HMT84G654B) should be maintained between the appliance and the wall. There should not be a back panel behind the appliance
  • Thickness of the panel in between 2 ovens - min. 10mm per panel.
  • Recommended ventilation area of 100cm² at the base of the cabinet
*Click on the first tab (Under counter) for exact appliance and cut-off dimensions.
Installation in certain situations
Online Survey