Find your dealer
Choose other country
Brand Alternative Text
Product Warranty Guide
Self Help Video
Spare parts & Accessories
Arrange an engineer visit
Living with Bosch
New Home Owners’ Guide
Bosch in every detail
Mother’s Day Promotion
Bosch Wok Series
Gourmet Made Easy
Plug Health Check
Top of page
Preparing the unit for installation
It is highly recommended that the cabinet units of the appliance is heat-resistance up to 90°C and adjacent cabinets up to 70°C
Some models of oven may require 15A or 20A single phase power supply. Ensure the requirement is fulfilled and the electricity connection of oven is performed by Registered Electrical Workers.
For best ergonomic result, it is highly recommended to install the appliance up to a height which allows trays and hot food to be easily and safely taken in and out.
For ventilation purpose, do not include a back panel for a cabinet
Cable Length: 1.2m (more than 3000watt does not come with plug)
AMP: Above 3500 not suitable for HDB
Proceed to Ventilation >
Preparing the unit for Ventilation
Ensure there is no backing panel behind the oven and minimum 20mm gap must be provided.
Recommended 100cm gap below the cabinet. Width of opening minimum 460mm.
Power point for Ventilation
Ideal to have powerpoint in the cabinet next to oven niche, however, if it is not possible, have it directly behind the oven.
In case of the need to have backing as a support frame work, here must have at least a
200mm x 400mm
opening here for air ventilation.
To install wire netting to prevent foreign matters dropping into cabinet.
Proceed to Installation >
Minimum 5mm gap must be provided between oven / steam oven fascia panel and cabinet for top and side.
Install the appliance only under continuous worktops which has been screwed to adjacent cabinets to ensure stability.
If the appliance is installed under a hob, please reserve at least 30mm gap between the hob and oven, or according to the minimum ventilation gap required by the hob installation manual, follow whichever is higher.
The power socket for the appliance must either be located in the hatched area A or else away from the installation space.
The appliance is 7mm taller than the IC5 equivalent. (HBG23B550, HBG43S450, HBG56B550, HBN331E2J)
For corner installation, check minimum clearances. Ensure that there is sufficient clearance A for the fron panel and its handles. Check that the appliance door can be opened properly.
Recommended 100cm2 at base of cabinet and 45mm behind appliances throughout. No back panel behind appliances.
Intermediate flooring is required when 2 appliances are on top of the other, except when appliance is installed above warming drawer.
Installation in certain situations
Top of page
Stay in Contact: