• Bosch corporate
 

{{ inductRadiant }} Hobs

> Home
Preparing the unit for installation
  • Gap: Remove shavings after performing cutting work.
  • AMP: Consult your electrician regarding household electrical loading capacity.
* Refer to specification sheet for actual connection load and measurements of the appliance model.
ABC
490-500mmmin. 50mmmin. 70mm
Preparing the unit for Ventilation
  • For ventilation, an opening at the back of the worktop is required.
*Read the instruction manual to check the area required for each model.
AB
550mm45mm
Example: PIN675N17E
NOTE2
  • Minimum gap below cabinet is 100cm² (60cm Hob).
NOTE1
  • Maintain a distance of at least 20mm between the hob and the wall for adequate ventilation
Ventilation in certain situations
NOTE1
  • Worktop: Ensure a minimum thickness of 20mm.
NOTE2
  • There should be a distance of 65mm between the top of the working surface and the top of the drawer.
NOTE1
  • Worktop: Ensure a minimum thickness of 20mm.
NOTE2
  • The distance between the oven and the hob must be at least 5mm.
  • If the distance between the hob and oven must be increased, refer to the installation instructions for the oven.
NOTE3
NOTE1
  • Worktop: Must have a minimum thickness of 20mm and maximum thickness of 40mm.
NOTE2
  • The space between the top of the working surface and the top of the dishwasher must be:
  • 60mm if installed over a compact dishwasher.
  • 65mm if installed over a full-size dishwasher.
Installation in certain situations
 
Online Survey